Comments on: Debugging the RS232 serial port

By: HA1AG

HA1AG — Sun, 02 Jan 2011 22:27:33 +0000

UFB analysis and troubleshooting. Toby! I’m experimenting with VSPE as my N8VB driver stopped functioning since the last XP update. 73 zoli ha1ag

By: Tobias

Tobias — Mon, 08 Nov 2010 20:34:57 +0000

Hey Sotiris,

no, I just did the debugging on the Yaesu FT1000MP. Since the FT1000MP is one of the few radios with two real receivers, this problem might only occur on a few more Ham Radio Transceivers.

In my FT1000MP I used a fixed frequency softrock clone. Since the IF frequency is always fixed (455kHz) there was no need to connect a tunable receiver to its Intermediate Frequency.

By: Sotiris SV1BDO

Sotiris SV1BDO — Mon, 08 Nov 2010 18:32:32 +0000

Very well written article Tobias!
Have you tried to add in the above configuration a software (Winrad or PowerSR-IQ) that will control an external SDR receiver, like PM-SDR? What will be the VSPE settings?
Have you tried your debugging procedure with other transceivers, like Kenwoods or Icoms?

73, Sotiris SV1BDO

By: CW Skimmer & FT1000MP, my wish | Contesting & SDR

CW Skimmer & FT1000MP, my wish | Contesting & SDR — Sun, 30 May 2010 02:33:37 +0000

[...] This made it impossible to use this setup in an operational contest environment. Check out my Win-Test & CW Skimmer investigation if you like to go down as deep as bit & bytes [...]

By: HAMRADIO_LY: wintelnetx , » LY Radio Lietuva

HAMRADIO_LY: wintelnetx , » LY Radio Lietuva — Tue, 23 Feb 2010 08:19:27 +0000

[...] Dabar besikuisdamas internete uztikau dar daugiau ta COMM port dalinanciu programeliu dykai. Labai geras straipsniukas ( nuoroda) ta tema: http://www.dh1tw.de/debugging-serial-port [...]

By: Lup

Lup — Wed, 02 Dec 2009 20:45:53 +0000

Hello Tobias!
tnx for this nice page. I do like your clean design and the praezise writen explanations very much.
Keep up the gus work!
55 de Lup DJ7SW/DL0KF

By: PAUL

PAUL — Sat, 28 Nov 2009 11:59:01 +0000

VSPE run ok and very easy to configure it.

BUT I never a running right with 2 softwares if each have a waterfall…

the maxi config.

mixwin + dxbase+atlas+rttyrite ( from writelog)+spectravue (soft panoramique for SDR-IQ no rs232 used

I read “langsam” your solution

73 paul F5QE